T300 pin out values

[Matthew Wilkinson]

Hi I picked up a T300 minus the cable, could someone with a multimeter and the T300/500 check the cable out values and furnish me with them, a thousand thanks.

 

[Case_]

What "cable out values" are you looking for?

 

[Matthew Wilkinson]

The four pin power cable, I do not have a power cable and wish to make my own and need to know what goes where. Thanks.

 

[asteroulis]

If you want to use with 220V then the two far ends are the ones you need. So I do suppose that the center ones are for 110v.
The thing is that you wont be able to find the particular 4 pin connector for a diy cable , and any other solution seems not reliable. So instead , I'd use a 24V 3+Amp power supply externally and replace the integrated one. That will reduce the thermal load as well.

 

[Matthew Wilkinson]

Thanks, that is what I am doing now, wondered if it was possible to make the cable but it seems fine as is with the inline fuse soldered in.

 

[asteroulis]

The EU cable doesn't have an inline fuse , the UK one does.

 

[Matthew Wilkinson]

Indeed but I Soldered one into the mix just to be sure I wasn't going too high Current wise, it's working really well now after some heavy use over the past week or so, thanks for the help guys.