Is there anyway to use GPS telemetry height data to import and use to create a more accurate track surface?
I was thinking about using the telemetry in my track car to collect close to real surface height changes.
Perhaps drive around the entire track, inside edge, then 1m over and again lap and then 1m over and so on until the outside edge. In essence srie 6 or so "lines" around the track to collect height data.
Not as accurate as LiDAR but cheaper and easier for the layman.
Thanks,
Paul
I was thinking about using the telemetry in my track car to collect close to real surface height changes.
Perhaps drive around the entire track, inside edge, then 1m over and again lap and then 1m over and so on until the outside edge. In essence srie 6 or so "lines" around the track to collect height data.
Not as accurate as LiDAR but cheaper and easier for the layman.
Thanks,
Paul