Knut Omdal Tveito
Premium
I recently upgraded my G27 and installed a load cell from APelectrix. But I'm having a slight problem with calibration of the load cell.
When I first plug in the wheel, I calibrate by pressing the brake to a maximum force I feel reasonable. After calibration it feels fine, but if I exceed that maximum force the brake will automatically re-calibrate and for the next braking zone I need a higher force to get 100 % signal. So after a few laps I'm having trouble to get 100% signal due to the re-calibration as the pedal requires alot of force at this point.
Anyone else experienced this and does anyone know a solution to this? Any way to fix the calibration range?
Thanks in advance,
Knut
When I first plug in the wheel, I calibrate by pressing the brake to a maximum force I feel reasonable. After calibration it feels fine, but if I exceed that maximum force the brake will automatically re-calibrate and for the next braking zone I need a higher force to get 100 % signal. So after a few laps I'm having trouble to get 100% signal due to the re-calibration as the pedal requires alot of force at this point.
Anyone else experienced this and does anyone know a solution to this? Any way to fix the calibration range?
Thanks in advance,
Knut