TH8 RS 3D printed short shift plate

Hor-hay · Mar 22, 2017

I've modeled and 3D printed myself a short shift plate with 7th gear blocked off. Did require a small amount of filling.

If anyone wants the model I'll upload it to the download section I'm guessing, can't upload here.

Insert Coin · Mar 23, 2017

Yes please

Moxley6969 · Mar 23, 2017

Upload it to Thingiverse, then post a link.

Hor-hay · Mar 23, 2017

Frig, can't upload it to the downloads section, I'll check out thingiverse...

Hor-hay · Mar 24, 2017

does this work, uploaded as a zip.
http://www.racedepartment.com/downloads/th8-shifter-short-shift-plate.14531/

Moxley6969 · Mar 24, 2017

Higher poly would be better imo. But looks ok for the most part.

Yes support will very much be needed.

Hor-hay · Mar 25, 2017

Moxley6969 said:
Higher poly would be better imo. But looks ok for the most part.

Yes support will very much be needed.

I don't know much about 3D printing, I'm more of an animator. Just got it printed through 3D-hubs, worked fine. Printed in ABS with 20% fill.

Moxley6969 · Mar 25, 2017

Higher poly = better details.....Im surprised the printer didn't pick up that wire mesh, but either way. Just a note for next time, a Higher poly wont ever really hurt anything, Except if its a MONSTER of a model and then yes a Super High poly count will make the file excessively large and be a bit heavy on resources.

Hor-hay · Mar 27, 2017

Moxley6969 said:
Higher poly = better details.....Im surprised the printer didn't pick up that wire mesh, but either way. Just a note for next time, a Higher poly wont ever really hurt anything, Except if its a MONSTER of a model and then yes a Super High poly count will make the file excessively large and be a bit heavy on resources.

Thanks for the tip, if anyone has issues I'll re-upload a higher poly version.