Replace Fanatec V1 V2 pedals connector

Discussion in 'Sim Racing Hardware' started by fux, Dec 2, 2018.

  1. fux

    fux

    Messages:
    8
    Ratings:
    +3
    Hallo,
    I need to replace the connector of my fanatec v1 pedal from load cell to PCB. I post 2 photos of the cable connector. The small connector (connection to pcb board) should be JST ZH 4 PIN 1.5 but I don'tk know wich type of connector is the one on the other end of the cable (connection to load cell)???
    The cable is identical to the ones connecting the accelerator and clutch hall sensors to pcb.
    The two connectors look the same in shape, obviously they have the same number of pins (4), but they have different dimension sizes
    Can you please help me? thanks
     

    Attached Files:

  2. WhippyVan

    WhippyVan

    Messages:
    20
    Ratings:
    +1
    it is just the next sized up JST 2.0mm if I remember correctly.
     
  3. fux

    fux

    Messages:
    8
    Ratings:
    +3
    Hi, Yes correct!. I've just verify that it's JST PH 2.0mm
    Then the cables from PCB to HALL SENSOR BOARD (accellerator and clutch) and from PCB to HALL SENSOR AMPLIFIER (BRAKE) have JST PH 4 PIN in one side and JST ZH 4 PIN in the other side.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.