RealFeel plugin

Status
Not open for further replies.
The problem with Realfeel is that the feedback force each of us feels is unique, due to our unique setups at both a hardware (wheel type) and software level (Windows driver revision used; Windows Control Panel settings; controller.ini tweaks; in-game wheel settings).

The key thing is to set Realfeel so that the hardest normal force experienced by the steering rack is 100% of feedback you get. It is common for sim racers to set Realfeel too low, as they do not like the softness of their wheel when travelling in a straight line.

  • Read the flippin manual to get the basics sorted out
  • Edit the realfeel.ini so that the console mode is enabled
  • Launch the rfactor config, drop down from your normal resloution and enable windowed mode
  • Start up rfactor, select a mod and a track with some good tarmac bumps such as the full course of Oulton 2005
  • Position your rf window and Realfeel console so that you can at least see the "%" column of the latter (helps to expand this console window to whole height of your monitor)
  • Drive round your test track, keeping an eye on the % value, especially through corners and bumpy sections
  • Use left Ctrl + Numpad 7/9 for 1000 unit changes; right Ctrl for 100 unit changes
  • If the steering feels really odd going just off straight on either side, press right Ctrl + Numpad 8
Sounds a hassle, but it really is worth spending a few minutes of your time to get values that are right for your setup!
 
Status
Not open for further replies.

Latest News

What would make you race in our Club events

  • Special events

    Votes: 62 29.1%
  • More leagues

    Votes: 41 19.2%
  • Prizes

    Votes: 44 20.7%
  • Trophies

    Votes: 26 12.2%
  • Forum trophies

    Votes: 14 6.6%
  • Livestreams

    Votes: 32 15.0%
  • Easier access

    Votes: 117 54.9%
  • Other? post your reason

    Votes: 35 16.4%
Back
Top