Some info for those of us that dont have a full rFactor2 install, you have to hack around a bit.
Your suggestion of this link:
Data Acquisition Plugin V1.3.2 Install [MediaFire]
when downloaded and you run the install requires a "valid" config.ini to run and install the plugin.
I only have the demo installed so the Acquisition install fails at 1st.
The demo rF2 config.ini is pretty empty so I copied GSC config.ini to the rF2 Core/Config.ini
and got farther. Found the the dll and README. Then I set the paths up in the ini file for the plugin and I ran GSC and did collect data (control m worked). Now I have to figure out why MoTeC does not think the
output file is input data. Using MoTec i2 Pro 1.0.21.0030. I do see a filetype .ld and .ldx with the
track name and time stamp.... Brasilia-2014_03_10_15_46_42-stint1.ld
MoTec says it does not see any files in my LOG/MoTeC folder with new versions of Motec.
On the install web page for the plugin I see they is a link to an old version of MoTeC
mi2_pro-wxp_1.01.0082
This version will read the plugin ld files and display the data.