Brake pedal only goes to about 30%

[bo1210]

Hey guys,

Windows 10, T300 RS wheel and T3PA pedals. This is a screenshot of the control panel with the brake FULLY pressed. The gas pedal and clutch go perfectly to 100%. I have uninstalled/re-installed the drivers and the wheel has the latest firmware. I switched out the T3PA with the pedals that came with the T300 and it did the same thing. No problems are showing in device manager. Asking here because I have a ticket in at Thrustmaster, but they are very busy and I'm not sure how long it will take for them to get back to me. Thanks in advance.View attachment 289960

 

[bubbi_177]

sounds wierd but i have had some kind of the same problem with my thrustmaster t150 i just unplugged the wheel and shut down the pc then plugged in again and turn computer on then the wheel set it self up again and then it worked

 

[mo86]

Looks like a wheelbase problem. Is it constant at 30% or is this the maximal value? Did you take a look at the rj11 connector and plug?

 

[bo1210]

Already tried that. Thanks.

sounds wierd but i have had some kind of the same problem with my thrustmaster t150 i just unplugged the wheel and shut down the pc then plugged in again and turn computer on then the wheel set it self up again and then it worked

 

[bo1210]

Plug and connector are both fine. Thanks.

Looks like a wheelbase problem. Is it constant at 30% or is this the maximal value? Did you take a look at the rj11 connector and plug?

 

[bo1210]

Thanks for everyone's help. I have decided to go with a different setup.

 

[Kenneth Jurmann]

That's normal when you are using the conical brake mod with not enough brake pedal travel.

Do you use the mod?