hi, lasercutter, so kind, thank you very much in deed, I have to say
Ok, I made a very quick reverse AIW which seems to work ok, it will at least allow you to use it as a base to work from.
There are still quite a few things that need doing
Pit in and out lights need repositioning and renaming>>>>>>>>>< ok done
Start lights need repositioning and renaming >>>>>>>>>>> ok done
Grid and pit markings need repositioning and renaming>>>>>>>>>>>>>>>ok done
Start locations will need redoing in aiw file to match grid markings >>>>>> ok done
Brake markers will need repositioning and renaming>>>>>>> ok
and maybe a few things I've forgotten too. >>>>>>>>>>>>>>>>> , the first thing that We should do is creating the new timming gates, setting then properly, rotating if necesary, and the result is a new gmt.
you can get the files here :----
http://www.mediafire.com/?kiy1yh78ibbdob2
hope they help.
good news, your AIW file works properly, I have taken your timing gates and pack in my MAS file, and it works
Bad news, I dont know why it works, the differences between yours and mine are the names, but I think that you rename as Xsector_01_rev, because you plan use the same gmt´s MAS file as Essington "normal", thus the Essington Rev SCN file instructions will "call" the right gmt, dont you?.
Ok, How did I make timming gates?, Ok I extract Xfinish, sector01 and sector02, with 3dsimed, and replace the material and texture (usually they are roads or grass texture) by the textures used by BTB, set in the right direction, thus I ensure that I set always the timing gates pointing to the right direction. At this point, you can say "maybe you have set them wrong, pointing to the wrong direction", ok, but if so, In trainning mode, or practice mode, the lap time will not be set, and it is set, so I asume taht are right( hum, I realized that I did not check that, what will rfactor do with wrong rotated timming gates)
The problem apperared in race mode, where between sector1 and finish line, car positions apperared with no sense, changing everytime!!
I m starting to think that my RF editor is no working fine, Could it be?
Thanks
Regards