pre tl:dr No response from the transducer or amps input activity monitor when using Simhubs "Test now" with a iNuke/Buttkicker LFE even though movies work just fine.
Simhub is confirmed to work using gas/brake transducers on their own soundcard. Also iNuke 3000dsp/BK LFE are working and tested with a movie on chrome YouTube, so hardware wise I think I'm ok. Problem seems to be software/Simhub. The "Test now" signal does not create any reaction in the transducer or amp input activity monitor. Also tested with tone sweeps/frequency tests videos from YouTube and a single tone generator, no luck even though movies on YouTube still work. Simhub was tested with a dedicated soundcard and also mixed with windows, no luck. Only non-Simhub/tone sweep audio is seen by the iNuke input activity monitor. iNuke was reset to defaults.
Is there a built in 60hz lowpass or something? But if that was the case than why does Jurassic Park work just fine? Does the iNuke ignore single tones? A feedback reducer???
Simhub is confirmed to work using gas/brake transducers on their own soundcard. Also iNuke 3000dsp/BK LFE are working and tested with a movie on chrome YouTube, so hardware wise I think I'm ok. Problem seems to be software/Simhub. The "Test now" signal does not create any reaction in the transducer or amp input activity monitor. Also tested with tone sweeps/frequency tests videos from YouTube and a single tone generator, no luck even though movies on YouTube still work. Simhub was tested with a dedicated soundcard and also mixed with windows, no luck. Only non-Simhub/tone sweep audio is seen by the iNuke input activity monitor. iNuke was reset to defaults.
Is there a built in 60hz lowpass or something? But if that was the case than why does Jurassic Park work just fine? Does the iNuke ignore single tones? A feedback reducer???