GSC wheel and keyboard controller.ini files

[Rick Malm]

Does anyone have a working Controller.ini file for Thrustmaster Ferrari GTE F458 wheel (7 buttons and a switch) that they could attach to a reply or give me a link? Just would like to know what people fine that they like on the wheel vs keyboard keys. Of course I put PIT on the Pit button, I used Button 8 switch at OFF for ignition, and position 2 of that sw for Starter and Scroll I set to look behind as just a place to staart,
The Flash button I set to boost. The Wiper button I set to LCD mode. 4 = reverse (for my spin outs). The other keys on the F1 wheel that are missing on the GTE wheel I scattered into keyboard keys. My GTE458 controller file is attached if you want it.

3/6/2014
By the way, If you have problems with keys looking like they are stuck (B9) with the Thrustmaster controller software like I did a few days ago, then most likely its your firmware level. When I upgraded from 38 to 41 version the software decided my wheel was a 458 not a GT and button 9 was no longer stuck on. I thought this was a hardware problem but Thrustmaster Support fixed me up with release 41.

3/5/2014 If you have older firmware for the GTE 458 you might see what I experienced. In the Thrustmaster control panel, go to properties and the TEST INPUT tab,
after the 1st button is pressed 9 stays on. If I dont press any buttons and just tap on the wheel
the 9 indicator comes on and stays on until I close the test window and select properties again. Also notice at the top of the controller Test input panel it shows GT wheel and not my Ferrari 458 wheel.