F1 2013 Fanatec CSR Setting advice

F1 2013 The Game (Codemasters)
Hopefully somebody can shed some light on this.

Using a fanatec CSR wheel, I notice that wheel on screen does not match the input I make with the wheel, however, it feels like my wheel input is correct. So essentially, it's as if the motion in game and my wheel is correct, but the onscreen wheel doesn't, sometimes only turning very slightly even though I am at 90degrees with the wheel.

If I use the game settings and tell it to override my wheel then the wheel and screen match, however the FF feels weak and poor, the steering lock is also quite weak too.
 
That's where I copied my settings from.

I do however, only have access to ffn strength and wheel weight, if select to override the wheel options.

At which point the ffb is very weak, with a steering lock that you can go past before it pulls it back to the lock a fraction after you have already steered past it.
 
Here is my Xbox 360 settings (I use Elite pedals)

Fanatec CSR Settings

SEN = 330
FF = 90
SHO = 100
DRI = Off
ABS = 85
LIN = 0
DEA = 0
SPR = -2
DPR = -3
ACL = Off

In Game Settings
Steering Deadzon = 0.50
Steering Saturation = 0
Steering Linearity = 0
Throttle Deadzone = 0
Throttle Saturation = 0
Brake Deadzone = 0
Brake Saturation = 10

Force Feedback

Environmental Effects = 100
Feedback Strenght = 100
Wheel Weight = 20
 

Latest News

What would make you race in our Club events

  • Special events

    Votes: 19 26.0%
  • More leagues

    Votes: 17 23.3%
  • Prizes

    Votes: 16 21.9%
  • Trophies

    Votes: 7 9.6%
  • Forum trophies

    Votes: 5 6.8%
  • Livestreams

    Votes: 14 19.2%
  • Easier access

    Votes: 46 63.0%
  • Other? post your reason

    Votes: 8 11.0%
Back
Top