Hi guys,
I was always under the impression (read it several times) that Fanatec hardware should keep its settings by wheel.
So, wheel 1 attached, for instance ffb 40% and when wheel 2 comes on that had previously a setting of 60%, it should automatically go to the 60%.
Well, it's not doing that.
Since a few days I got another wheel and it's annoying the H... out of me already
I keep going over all the settings, forgetting half of them (make that 99%).
So, is there something I should do, set, install or something like that, am I missing something here?
I was always under the impression (read it several times) that Fanatec hardware should keep its settings by wheel.
So, wheel 1 attached, for instance ffb 40% and when wheel 2 comes on that had previously a setting of 60%, it should automatically go to the 60%.
Well, it's not doing that.
Since a few days I got another wheel and it's annoying the H... out of me already
I keep going over all the settings, forgetting half of them (make that 99%).
So, is there something I should do, set, install or something like that, am I missing something here?