overpass in one track

F

Fatboymart

I also had this problem in an earlier version of BTB with walls, I didn't get to the bottom of the problem due to be distracted in work then leaving the project on hold for a while.

I'd be keen to understand the solution also.

Martin
 

speedstr001

10RPM
May 9, 2009
20
0
no i don't think so Erwin. in the pic is the race line all out of whack. This also
causes a crash when trying to set the start position as soon as you try to move it.I don't see a grounded opt in the track surface either.
 

banger

500RPM
Mar 24, 2009
661
33
55
in the wall properties section, you can selected if the objected is grounded,or inserted halfway into ground.
 

speedstr001

10RPM
May 9, 2009
20
0
Just to clarify the pic. The object dropped down to the bottom is the race line not a wall or any object. When looking at race line,fast line or pit line this is what happens. The top of track race line drops to the bottom and the bottom track race line goes up to the top portion of track where the 2 overlap.
 

banger

500RPM
Mar 24, 2009
661
33
55
Just to clarify the pic. The object dropped down to the bottom is the race line not a wall or any object. When looking at race line,fast line or pit line this is what happens. The top of track race line drops to the bottom and the bottom track race line goes up to the top portion of track where the 2 overlap.
ahhh, i still use the aiw v1.255editor.:computer: