General Flames Timing CSP

[FloppyNiple]

Ive tried looking everywhere and see alot of other peoples questions going unanswered. If the creators of CSP or any modders out there that can explain how to mess with CSP backfire/flame timing. if there isnt a way then maybe a new setting in next update?? Ive tried messing with flames.ini, flame_presets.ini, and sounds.ini
idk what else to do

 

[Kevin Troschinski]

Sorry warming up this threadt, but i had no luck in other one....
My question comes near the original post, because its about flames.

Can someone who uses the 1.76 CSP tell me, if the exhaust flames at AI cars are working again please? (Buggy with 1.74, 1.75).

EDIT: ok forget it found the answer elswhere

 

[Ben Lee]

I think this goes into the config file for the car itself...
[EXHAUST_FLAMES]
ANTILAG=0 ;unknown
ANTILAG_DELAY=0.05 ;unknown
ANTILAG_INTENSITY=2 ;unknown
ANTILAG_INTERVAL_MAX=1.0 ;unknown
ANTILAG_INTERVAL_MIN=0.5 ;unknown
ANTILAG_TURBO_THRESHOLD=0.9 ;unknown
DISCHARGE=1 ;off-throttle flame enabled 1=yes, 0=no
DISCHARGE_CHARGE_TIME=0.9 ;i think amount of throttle needed to fulfil criteria for flame appearing
DISCHARGE_DELAY=0.1 ;delay until flames start appearing after release of throttle
DISCHARGE_DURATION=2 ;duration of the flame
DISCHARGE_INTENSITY=0.4 ;size of the flame, higher number = bigger flames
DISCHARGE_PROBABILITY=0.6 ;probability of flames appearing per release of throttle
DISCHARGE_RPM_THRESHOLD_MAX=6000 ;unknown
DISCHARGE_RPM_THRESHOLD_MIN=500 ;unknown
DISCHARGE_WATER_TEMPERATURE_THRESHOLD=2 ;unknown
FLAT_SHIFT=1 ;flat shift flame enabled 1=yes, 0=no
FLAT_SHIFT_COOLDOWN=0.01 ;unknown
FLAT_SHIFT_DURATION=0.0005 ;duration of the flame
FLAT_SHIFT_GAS_THRESHOLD=0.5 ;unknown
FLAT_SHIFT_INTENSITY=0.01 ;size of the flame, higher number = bigger flames
FLAT_SHIFT_PROBABILITY=0.5 ;probability of flames appearing per shift
FLAT_SHIFT_RPM_THRESHOLD=6000 ;RPM of car where above this rev range the flame should appear
LIMITER=1 ;limiter flames enabled 1=yes, 0=no
LIMITER_DELAY=0.3 ;delay until flames start appearing upon hitting the threshold
LIMITER_INTENSITY=1 ;size of the flames, higher number = bigger flames
LIMITER_RPM_THRESHOLD=8500 ;set this near (below) the cars rev limiter

 

[GanjaDon420]

@Ben Lee Hello, could you please tell me where u get this [EXHAUST_FLAMES] from ?
non of my cars i looked in the folder got that in the data folder. thers only flames and flames preset.
on csp 1.60 the flames are ok but on 1.75 i got no flames when i get of the throttle.

 

[Ben Lee]

Yea this needed to go in the cars config.ini which CSP uses. Each car should have one in the extension folder per car.