Physics Could you provide a multilink suspension example?

[vkristof01]

Hey Guys,
I'd like to reproduce the rear multilink suspension of my IRL BMW. I roughly measured it's pieces but i don't know how to put things into the suspension.ini because obv. this has more/different parts than DWB.

I know DWB is roughly correct but i'm curious how the car would feel done properly.

 

[AccAkut]

[REAR];
RIM_OFFSET=0
TYPE=ML
BASEY=-0.097
TRACK=1.63
ROD_LENGTH=0.019                       
HUB_MASS=50;   

;Lower arm front
JOINT0_CAR=
JOINT0_TYRE=

;Upper arm front
JOINT1_CAR=
JOINT1_TYRE=

;Arm lower middle
JOINT2_CAR=
JOINT2_TYRE=

;Arm upper rear
JOINT3_CAR=
JOINT3_TYRE=

;Toe linkage back
JOINT4_CAR=
JOINT4_TYRE=


TOE_OUT=0.00048
STATIC_CAMBER=-2.4
SPRING_RATE=179000;
etc.

The Kunos code for the Multilink rear of my Porsches, using typical X, Y, Z coordinates. I suppose CSP got it's own new code if that's what you're after, no idea how to create that

 

[vkristof01]

Thank you, this is everything i wanted. Not all that different as i thought thou.

 

[Enrique23]

This didn't work for me. I'm editing while using CM Showroom to see the actual suspension pickup points and the rear suspension completely disappeared when I used the above format

 

[Stereo]

CM Showroom doesn't do suspension points correctly even on types where it can draw them, you should use other visualization methods.