CM & CSM changes to ff_post_process?

Is the auto installer for Content Manager overwriting a part of the ff_post-process.ini file in the Documents/AC/cfg/ff_pp file?
I started the sim this morning and my wheel went 'nuts', (buzzing and shaking) with the car just sitting in the pits.
It was not really 'drive-able'...since it continued rocking violently back and forth on track s...even going straight.
I exited went and did the LUT configuration and that restored it.
I then went into CM a bit later and loaded the recommended CSP (140...I believe) and again the wheel went nuts.
I again exited and on checking the PP file, it had the entire LUT setting missing.
 
  • Deleted member 197115

CM settings overwrite manual config changes.
Either match them or make you manually modified file Read Only.
 
In CM you enable a lut like this:
knkn40d.png


in general principle gamma should never be anything except 100%, and if you use a lut with a notch at the beginning (like the one in the screenshot) you need to set min. force to 0%.
 

Latest News

Online or Offline racing?

  • 100% online racing

    Votes: 73 7.3%
  • 75% online 25% offline

    Votes: 102 10.3%
  • 50% online 50% offline

    Votes: 145 14.6%
  • 25% online 75% offline

    Votes: 272 27.4%
  • 100% offline racing

    Votes: 398 40.0%
  • Something else, explain in comment

    Votes: 4 0.4%
Back
Top