Hi there I have searched everywhere I have this car downloaded from steam
Brabham BT6 Formula Junior
I would like to edit the handling and so on of the car :-
Spring Rate 275 Lbf/in 300 Lbf/in
Ride Height 67 mm under front bulkhead
just above bodywork
70 mm under rear of chassis
under triangulation tubes
Static Camber -1.75 Degrees -0.75 Degrees
Droop
Minimum 15 mm at dampers
at SRH (also fit droop
restrictor tab if possible)
Minimum 35 mm
Castor 4.5 degrees N/A
Toe** 0.2 Degrees OUT 0.25 Degrees IN
ARB O/D 0.75 in (NEW) 0.5 in
ARB I/D 0 in 0 in
ARB Lever Arm* 155 mm (NEW) 185 mm (NEW)
Dampers SEE NOTES BELOW
Tyre Pressures
(starting point, refine
through temperature)
18 psi HOT 21 psi HOT
Bump Rubber KONI 8212 30 mm parallel KONI 8212 40 mm parallel
Packers (Damper
Clearance @ SRH) 9 mm 25 mm
Am aware i may not be able to set it all up, also if anyone can do it am happy to make a small donation if needed.
Brabham BT6 Formula Junior
I would like to edit the handling and so on of the car :-
Spring Rate 275 Lbf/in 300 Lbf/in
Ride Height 67 mm under front bulkhead
just above bodywork
70 mm under rear of chassis
under triangulation tubes
Static Camber -1.75 Degrees -0.75 Degrees
Droop
Minimum 15 mm at dampers
at SRH (also fit droop
restrictor tab if possible)
Minimum 35 mm
Castor 4.5 degrees N/A
Toe** 0.2 Degrees OUT 0.25 Degrees IN
ARB O/D 0.75 in (NEW) 0.5 in
ARB I/D 0 in 0 in
ARB Lever Arm* 155 mm (NEW) 185 mm (NEW)
Dampers SEE NOTES BELOW
Tyre Pressures
(starting point, refine
through temperature)
18 psi HOT 21 psi HOT
Bump Rubber KONI 8212 30 mm parallel KONI 8212 40 mm parallel
Packers (Damper
Clearance @ SRH) 9 mm 25 mm
Am aware i may not be able to set it all up, also if anyone can do it am happy to make a small donation if needed.
