I'm having a couple of issues with the new AIW editor in BTB 0.800.
Firstly the Teleport section stagger & 2nd row offset measurement boxes will not accept decimal points.
ie: it will accept 16.00 but not 16.07.
An option here to copy the grid settings would be useful as most of the time I think they would be the same anyway.
Secondly I was editing my garage positions & to get them in the right place i had to un-tick attached which is fine but when i did this some of the positions were over the terrain.
I found that i could manually move the one which were over the road surfaces but the ones over the terrain I could not move.
The solution was to re-tick attached & move them all over road surfaces.
Then un-tick attached again & i could move them all.
If anyone else could confirm these problems occur on other machines that would be good.
Cheers
I am running Vista64, NV8600GT, 0.800 BTBPro
Firstly the Teleport section stagger & 2nd row offset measurement boxes will not accept decimal points.
ie: it will accept 16.00 but not 16.07.
An option here to copy the grid settings would be useful as most of the time I think they would be the same anyway.
Secondly I was editing my garage positions & to get them in the right place i had to un-tick attached which is fine but when i did this some of the positions were over the terrain.
I found that i could manually move the one which were over the road surfaces but the ones over the terrain I could not move.
The solution was to re-tick attached & move them all over road surfaces.
Then un-tick attached again & i could move them all.
If anyone else could confirm these problems occur on other machines that would be good.
Cheers
I am running Vista64, NV8600GT, 0.800 BTBPro