Hey all,
Need some help.
I've tested both gauges individually on Pin 5 and both don't seem to give me the correct values. The pins bounce when testing Boost Zero and/or Manual Position Test (temp gauge)
Any idea what the problem might be?
When connecting both of them to the Arduino Nano, i use pin 5 for boost gauge and pin 8 for temp gauge.
On pin8, the water temp gauge doesn't seem to move at all even though it gets a reading from simhub but does not hold it's value when doing the manual position test. It just bounces up once and then goes back to the lowest value.
Any idea what this could be?
Need some help.
I've tested both gauges individually on Pin 5 and both don't seem to give me the correct values. The pins bounce when testing Boost Zero and/or Manual Position Test (temp gauge)
Any idea what the problem might be?
When connecting both of them to the Arduino Nano, i use pin 5 for boost gauge and pin 8 for temp gauge.
On pin8, the water temp gauge doesn't seem to move at all even though it gets a reading from simhub but does not hold it's value when doing the manual position test. It just bounces up once and then goes back to the lowest value.
Any idea what this could be?
