Hi I have an Fosi Audio USB Soundcard/AMP Issue.
My PC will not recognise them as two seperate devices.
Any idea what i need to do?
They are like the nobsound minis accept they output 100w+100w
Thanks
Hello guys I have been following alot of your work with bass shakers and its super impressive. I started with a ps4 and a single buttkicker kit and then found this forum...
This is what I am using now
Trak racer 180 aluminum profile rig
Amps
Behinger nx1000d (dsp)
Buttkicker BKA-130-C...
Hi all,
This my first post!
Not sure if this is the right place for this I designed a Dayton TT25 Bass Shaker mount for the Fanatec Clubsport V3 Accelerator and Brake pedals to replace the existing vibration motors.
I printed and installed it on mine set and it works brilliantly along side...
As a small offering of appreciation for those who contribute to this community,
attached is a SimHub ShakeIt bass shaker profile
that provides tactile sensations below frequencies
for which Dayton exciters and pucks deliver useful energy.
It operates on the same principle as AM radio,
namely...
I've been researching for project for a long time and kept deferring it for multiple reasons, but I am ready to take it on. I won't mention to much to begin with as I am trying to figure out the best method (practically priced) for where to mount a tactile transducer of some sort to my seat to...
Hello all! I'm looking to add tactile transducers/bass shakers. Mr Latte has given me the bug in wanting to add them to my 8020 custom sim racing rig. I mainly race iRacing and a little bit of ACC and PC1, and PC2. My sim racing seat is a Kirkey 65 Series 17" seat. All points of contact with the...
Hello,
I would like to get some advice how to setup iNuke 1000DSP to work well with 2x Bass Pump III transducers. They are rated for RMS capacity 50 W and Max. audio capacity 80 W.
What should be the maximum output set from the amp to not cause any damage?
Im also thinking about more stronger...
Hello everyone
I have 2 AuraSound AST-2B-4 Pro Bass Shakers I would like to use with an older Yamaha (RX-V595, 70 w/channel) receiver. The AuraSound will be mounted rear-right and rear-left, I will eventually add 2 more of these shakers front-right and front-left.
I am looking for clear...