• Racing is not a matter of life and death. It's much more important than that!
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. If you have any questions, please don't hesitate to ask. There's no such thing as a stupid question.

Pitline away from pitlane contours

Discussion in 'Bob's Track Builder' started by wildside, May 31, 2012.

  1. wildside

    wildside

    Messages:
    37
    Ratings:
    +1
    I need to figure out an idea on how to fit the line that is designated as a pitlane that matches within the centre of it, so that the corridors cannot stick out, like that photo shown below:
    [​IMG]
     
  2. Lee Knight

    Lee Knight

    Messages:
    955
    Ratings:
    +240
    Hold 'Ctrl' key and click on the line so you can add more 'pins'....
    Adding more 'pins' also adds more corridor control lines too...
    Either used view 1 (2D above or 3D view & turn on wireframe mode (W key) to make sure they're central to the track.
    The end 'pins' that join Pit Lane to the main/fast path can only be moved in 3D view, the others can be moved in any view....
    I personally refer to those little blue dots as 'pins' because they only hold the AIW lines, they have nothing to do with the spacing of the AIW way points...
     
  3. wildside

    wildside

    Messages:
    37
    Ratings:
    +1
    Thank you very much!
    Now i see it happening in action