• Race hard. Race fair.
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

"Paint" on Track

Discussion in 'Bob's Track Builder' started by Ralf Ääro, Jun 25, 2009.

  1. Ralf Ääro

    Ralf Ääro

    Messages:
    288
    Ratings:
    +87
    Hello

    is there an "easy" way of painting lines on the track?
    And I dont mean Textures with lines on it, like the default Tarmac Texture. ;)
     
  2. banger

    banger

    Messages:
    661
    Ratings:
    +32
    use a wall, flating the center nodes.and move to position:)
     
  3. Ralf Ääro

    Ralf Ääro

    Messages:
    288
    Ratings:
    +87
    I tried that, but it seems, that there are problems with rendering, because sometimes the "painted lines" are disappearing into the ground. Not always, just at some Parts. ;)
     
  4. chub_pearson

    chub_pearson

    Messages:
    312
    Ratings:
    +2
    That will be where they are too close to the ground at that point. AFAIK the line should be 2 cm+ above the track surface. Try adding extra control points where it's too low and raising it up a bit.
     
  5. Ralf Ääro

    Ralf Ääro

    Messages:
    288
    Ratings:
    +87
    I think thats working but, its VERY tricky to do that and it takes me hours just for some lines ;)
     
  6. still_bacon

    still_bacon

    Messages:
    415
    Ratings:
    +159
    If that is taking too long to do, then the best option is to create a custome texture with the lines on it.

    You would never have this problem then.