• "Mwoah" - Kimi Räikkönen
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. Dear Guest. Follow RaceDepartment on Twitter, Facebook, Instagram, Twitch, Steam and YouTube.

Fanatec CSW V1 PSU

Discussion in 'Sim Racing Hardware' started by Robby P, May 27, 2017.

  1. Robby P

    Robby P

    Messages:
    3
    Ratings:
    +1
    Hello, I'm new to the forum and had a question i cannot find an answer to anywhere. I found a V1 base and wheel for a really good price but...there aren't any cables. I'm assuming no one except Fanatec makes the PS/2 to RJ-12 cable so i was going to order those, unless anyone knows a third party or somewhere else to get them? To my question about the PSU.. If I buy a supply with the same input and output ratings will it work with the base? I'm not sure if they use an off size plug so that it can't be done. Any reply is greatly appreciated. Thank you
     
  2. rocafella1978

    rocafella1978
    Premium

    Messages:
    592
    Ratings:
    +98
    look for Nick Mosley in various forums, I think he is active here too, but he has all your answers he even modded his servo/ motor in his V1. i am sure he can help, as I found him to be one of the most helpful members/ simracers with any sim related stuff! good luck.
     
    • Like Like x 1
  3. Robby P

    Robby P

    Messages:
    3
    Ratings:
    +1
    rocafella1978 Thanks for the advice!
     
    • Like Like x 1