• "Slow and steady finishes the race. Fast and steady wins the race." - Sean Rogers.
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

CSP v2 help

Discussion in 'Sim Racing Hardware' started by dmgp1, Apr 8, 2016.

  1. dmgp1

    dmgp1

    Messages:
    6
    Ratings:
    +0
    Posted in another forum but found ni answer.
    Just purchased CSP v2 pedals used, found the flanged nut or thumb nut missing from the brake pedal to the shock, does anyone know what I can replace it with? I know some RC companies sell flange nuts but unsure if they would work. Also would like to know what I can replace the button head screws for the load sell with as the heads are stripped. Are they m2 screws?

    Any help would be appreciated

    Thanks
     
  2. Jari Vinnari

    Jari Vinnari

    Messages:
    3,605
    Ratings:
    +923
    I lost my adjustment knob of my V1 pedals and replaced it with one found in Ebay.
    It the saft is D-shaped then in Ebay search for "knob d-saft" but remember to check the diameter of saft.
    Another type search in Ebay would be "potentiometer knob".
     
  3. Moxley6969

    Moxley6969

    Messages:
    521
    Ratings:
    +203
    M3 is what your looking for the shock retaining nut and the smaller Load cell screw's Are an M4 thread.
     
  4. dmgp1

    dmgp1

    Messages:
    6
    Ratings:
    +0
    Jari thank you for the information but I'm not looking for the knob for adjusting the load cell but thanks again.
    Thanks moxley that is exactly what I was looking for .
    Really appreciate the help from both of you.